Differences between revisions 5 and 7 (spanning 2 versions)
|
Size: 1240
Comment:
|
← Revision 7 as of 2020-05-01 22:16:47 ⇥
Size: 1322
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 20: | Line 20: |
| Tucnak als Log Tool für 1. Mai AOEE https://devlol.org/wiki/docviper/tucnakforaoee |
|
| Line 21: | Line 25: |
{{{ |
|
| Line 22: | Line 28: |
| }}} | |
| Line 24: | Line 31: |
| Line 27: | Line 36: |
cd PrusaSlicer-version_2.1.0/ |
|
| Line 28: | Line 39: |
| cd PrusaSlicer-version_2.1.0/ |
|
| Line 33: | Line 42: |
| }}} {{{ |
|
| Line 36: | Line 44: |
| }}} {{{ |
|
| Line 39: | Line 46: |
| }}} {{{ |
docviper aka Joe
Email: <OE5JFE AT SPAMFREE oevsv DOT at>
Name: Joe
QRZ: https://www.qrz.com/db/OE5JFE
Projekt Ideen: J-Pole Antenne für 2m/70cm
- 300 Ohm Leitung von DX-Wire
- RG 58 mit BNC oder SMA
- Litze
- Schrumpfschlauch mit Schmelzkleber
Tucnak als Log Tool für 1. Mai AOEE https://devlol.org/wiki/docviper/tucnakforaoee
Mini-Howto: Prusa-Slicer 2.1 für Lubuntu vom Source bauen
wget https://github.com/prusa3d/PrusaSlicer/archive/version_2.1.0.tar.gz
.tar.gz entpacken
Nötiges installieren
sudo apt install cpanminus cmake libboost-all-dev libtbb2 libtbb-dev libcurl4 libmkl-tbb-thread libcereal-dev libeigen3-dev expat libgtest-dev libcurl4-openssl-dev wx-common libplplotwxwidgets1 libwxgtk3.0-dev cd PrusaSlicer-version_2.1.0/
build
perl Build.PL mkdir build cd build/ cmake .. -DCMAKE_BUILD_TYPE=Release -DSLIC3R_WX_STABLE=1
deb bauen
sudo checkinstall
starten
prusa-slicer